Home »
» Programming the MCU
- Connect the programmer
module to the serial port of your computer.
- Insert
the AT89C2051 or AT89C4051 device to program in the ZIF socket of the Programmer
module. Pins 10 and 11 of MCU (located at lower bottom) must be connected to
the bottommost pins of the ZIF socket (pin 12 & 13)
- Plug the DC jack of the
adaptor to the Programmer module then plug the adaptor to the AC outlet to turn
on the power.
- Run the ALEXAN ATMEL PROGRAMMER software
- At startup of the
software, it will automatically search for and connect to the serial port the
Programmer module is connected to. Alternately, you may select the serial port
to connect to by selecting the Serial Port Setup (press F9). After
selecting the appropriate COM port, press OK. The programmer will then search
for your Programmer module.
- Choose AT89C2051 from
the dropdown box (press F11) to program AT89C2051 MCU or AT89C4051 (press
F12) to program AT89C4051MCU. Make sure that the selected IC in the software
matches that of the IC you have inserted in the Programmer module. Information
about the device you choose is shown on the right side.
- Open a hex file (*.hex). Click
open file. Make sure that your compiler generates a hex file from your source
code since the programmer will only allow a valid hex file format with a *.hex
extension to be opened. The hex code is shown on the current active buffer tab.
A maximum of 3 files may be opened.
- To program, on the Tools
menu, click Program Device (press F5).
Good day Sir.Just for a review lang po. Ask ko lang po kung ano 'yung gagawin, once na nagawa naman po ng tama 'yung buong process na iyan then kapag ni-run na, nagfe-failed po.?
ReplyDeleteGood pm Sir. Is it important to unchecked the lockbit 1 & 2? What will happen if I run the program and the lockbit 1 & 2 has been checked?
ReplyDeleteWhat will happen if I inserted the DC jack first before the IC 2051? Also why do we need to make sure that the IC notch is properly inserted ? thank you in advance
ReplyDelete